Test Modes

Fully Automatic Mode

•  Pre-start procedure can be defined
  •  Clear faults in ECM
  •  Oil prime
  •  Coolant fill
  •  Etc.
•  Engine can be started automatically or with operator intervention
•  Test sequences run without operator intervention
•  Operator prompt/response can be set up during test
•  Safeties are checked continuously during the test
  •  Warning – Highlight parameter in yellow
  •  Safety – Highlight parameter in red and perform a normal shutdown of the engine
  •  Emergency – Highlight parameter in red and perform an immediate shutdown of the engine
•  A check limits macro can be included in any test procedure to check for pass or fail condition of any parameter
  •  Continue test on failure option
  •  Shutdown test on failure option
•  Test data is collected when requested in any test procedure
•  Engine is shutdown at the end of the test
•  Engine pass / fail determined
•  Test data automatically sent to host computer or kept locally
  •  Test data kept in mail box if host is down
•  Shutdown data capture (flight recorder)

Automatic Mode Screen

Semi Automatic Mode

• Test sequences initiated and concluded by operator
• Operator prompt/response can be set up during test
• Can retain all of the features presented in fully automatic mode

Manual Mode

• Operator can run engine outside of test sequence
• Safeties are checked continuously during the test
  • Warning – Highlight parameter in yellow
  • Safety – Highlight parameter in red and perform a normal shutdown of the engine
  • Emergency – Highlight parameter in red and perform an immediate shutdown of the engine

Manual Mode Screen